资 源 简 介
In 2009, labview-srv was created by Dr Chris Rogers of Tufts University (http://www.tufts.edu/~crogers/) and Tim Jump of Benilde-St Margaret"s School, using QT libraries by Christophe Salzmann of EPFL. This labview control interface was developed for use with the Surveyor SRV1 Blackfin control board.
Instructions for use of the original control interface:
Launch MainController2.vi or SRV_DEMO_VI.vi from Labview 9.0, change the IP address to match your SRV-1 / SVS setup, and then start the script.
Surveyor Corp. has closed, along with the Surveyor User Forum and Surveyor components are no longer available, but development of the MainController interface has continued along with development of a new set of components derived from the SRV.
Repositories for the latest versions of Maincontroller, along with all the new components are on Git Hub (https://github.com/Engineering-3). The Open Source licenses used for the original MainController and Surveyor components
文 件 列 表
labview-srv
.DS_Store
_SubVIs
A_D_Reading.vi
BatteryReading.vi
Camera_AutoGain.vi
Camera_AveYUV.vi
Camera_Histogram.vi
Camera_LocalYUV.vi
CameraAutoSegmentation.vi
CameraSetup.vi
CameraThreshold.vi
Compass_5843_Reading.vi
Compass_6532_Reading.vi
dir.mnu
DownloadFile.vi
GetImage.vi
ImageFlip.vi
ImageProcessing
ImageQuality.vi
Lasers.vi
MainController2.vi
PicoC_Mode.vi
RTC_Reading.vi
SetMotors.vi
SetMotors_2.vi
SRV_DEMO_VI.vi
SRV_DriveMotors.vi
Tilt_Reading.vi
Version.vi
