This leon3 design is tailored to the Altera NiosII Startix2 Development board, with 16-bit DDR SDR

This leon3 design is tailored to the Altera NiosII Startix2 Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM. As of this time, the DDR interface only works up to 120 MHz. At 130, DDR data can be read but not written. NOTE: the test bench cannot be simulated with DDR enabled because the Altera pads do not have the correct delay models. * How to program the flash prom with a FPGA programming file 1. Create a hex file of the programming file with Quartus. 2. Convert it to srecord and adjust the load address: objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec 3. Program the flash memory using grmon: flash erase 0x800000 0xb00000 flash load fpga.srec